Published on Feb 21, 2020
Wireless Integrated Network Sensors (WINS) now provide a new monitoring and control capability for monitoring the borders of the country. Using this concept we can easily identify a stranger or some terrorists entering the border.
The border area is divided into number of nodes. Each node is in contact with each other and with the main node. The noise produced by the foot-steps of the stranger are collected using the sensor.
This sensed signal is then converted into power spectral density and the compared with reference value of our convenience. Accordingly the compared value is processed using a microprocessor, which sends appropriate signals to the main node. Thus the stranger is identified at the main node. A series of interface, signal processing, and communication systems have been implemented in micro power CMOS circuits. A micro power spectrum analyzer has been developed to enable low power operation of the entire WINS system.
Thus WINS require a Microwatt of power. But it is very cheaper when compared to other security systems such as RADAR under use. It is even used for short distance communication less than 1 Km. It produces a less amount of delay. Hence it is reasonably faster. On a global scale, WINS will permit monitoring of land, water, and air resources for environmental monitoring. On a national scale, transportation systems, and borders will be monitored for efficiency, safety, and security.
Wireless Integrated Network Sensors (WINS) combine sensing, signal processing, decision capability, and wireless networking capability in a compact, low power system. Compact geometry and low cost allows WINS to be embedded and distributed at a small fraction of the cost of conventional wireline sensor and actuator systems. On a local, wide-area scale, battlefield situational awareness will provide personnel health monitoring and enhance security and efficiency. Also, on a metropolitan scale, new traffic, security, emergency, and disaster recovery services will be enabled by WINS. On a local, enterprise scale, WINS will create a manufacturing information service for cost and quality control.
The opportunities for WINS depend on the development of scalable, low cost, sensor network architecture. This requires that sensor information be conveyed to the user at low bit rate with low power transceivers. Continuous sensor signal processing must be provided to enable constant monitoring of events in an environment. Distributed signal processing and decision making enable events to be identified at the remote sensor. Thus, information in the form of decisions is conveyed in short message packets. Future applications of distributed embedded processors and sensors will require massive numbers of devices. In this paper we have concentrated in the most important application, Border Security.
Conventional wireless networks are supported by complex protocols that are developed for voice and data transmission for handhelds and mobile terminals. These networks are also developed to support communication over long range (up to 1km or more) with link bit rate over 100kbps. In contrast to conventional wireless networks, the WINS network must support large numbers of sensors in a local area with short range and low average bit rate communication (less than 1kbps).
The network design must consider the requirement to service dense sensor distributions with an emphasis on recovering environment information. Multihop communication yields large power and scalability advantages for WINS networks. Multihop communication, therefore, provides an immediate advance in capability for the WINS narrow Bandwidth devices. However, WINS Multihop Communication networks permit large power reduction and the implementation of dense node distribution. The multihop communication has been shown in the figure 2. The figure 1 represents the general structure of the wireless integrated network sensors (WINS) arrangement.
Are you interested in this topic.Then mail to us immediately to get the full report.
email :- contactv2@gmail.com |